Product features
Simple and time-saving installation, easy to follow construction
Elastic reinforcement of critical motion zone
High strength while maintaining high elasticity
Compatible with waterproof coatings and cement-based adhesives
Resist cracks at the junction of the base layer and water pipes to prevent water leakage
Usage
Suitable for 75mm diameter hot and cold water inlet and outlet pipes or other similar diameter water pipes.
Step 1- Clean the base layer at the root of the pipe and any dirt and dust adhering to the surface of the water pipe.
Step 2- Use a brush to evenly apply the waterproof rubber film or other waterproof film that meets the requirements around the pipe root. The coating surface should exceed the total width of the waterproof pipe root sleeve (hereinafter referred to as the pipe root sleeve), and apply waterproof coating with a height of about 2-3cm along the outer wall of the pipe.
Step 3- Insert the root sleeve into the top of the drainage pipe, press it down from top to bottom, and ensure that the root sleeve is located in the middle of the joint of the pipe root. Use a brush or shovel to lightly press the root sleeve to ensure that it is completely attached to the waterproof film, without arching or flipping, and forms a flipping edge of about 1cm with the root of the water pipe.
Step 4- Apply another layer of waterproof film evenly on the surface of the root canal sleeve, ensuring that the non-woven fabric around the root canal sleeve and the junction of the water pipe root are completely covered by the waterproof rubber film.
Step 5- After the first layer of waterproof film is completely dry, apply a thin layer of waterproof film for reinforcement.
